Cyclic Defect - Oki OKIPAGE 6w Maintenance Manual

4 Vertical black belt/stripe
• Replace the I/D unit.
• Has this error been recovered?
• Yes
• No Replace the LED head.
• Has this error been recovered?
• Yes
• No Replace the main control board, high-voltage power supply board(P2H) or high-voltage
power supply board(P6L).
5

Cyclic defect

EP drum
Developing roller
Toner supply roller
Charge roller
Cleaning roller
Transfer roller
Heat roller
Pressure roller B
Caution: After replacing the I/D unit, reset the drum counter. (Refer to "Replacing the Drum
Cartridge" in "User's Manual".)
End
Caution: After replacing the I/D unit, reset the drum counter. (Refer to
"Replacing the Drum Cartridge" in "User's Manual".)
End
Caution: Set the LED head drive time when replacing the LED head. (See
Section 4.2.1.)
Cycle
1.98" (50.3 mm)
1.44" (36.6 mm)
2.63" (66.8 mm)
0.81" (20.6 mm)
0.81" (20.6 mm)
1.71" (43.4 mm)
2.46" (62.5 mm)
2.35" (59.7 mm)
Remedy
Clean or replace the I/D unit.
Replace the I/D unit.
Replace the I/D unit.
Replace the I/D unit.
Replace the I/D unit.
Replace the I/D unit.
Replace the heater Assy.
Replace pressure roller B.
6 - 15