Slant/Fin VICTORY VSPH SERIES User's Information Manual page 3

3
INSPECTION
Your boiler and heating system will last an indefinitely
long time at full efficiency, if it is inspected regularly
and is kept in good repair and adjustment. You, the
user, should make regular inspections, and report any
problems to your service agency. At regular intervals,
you should have that agency inspect the system,
clean the boiler and make repair adjustments as nec-
essary. what you and the service agency should do is
listed below. Contact your gas supplier for a list of
qualified service and repair agencies.
USER INSPECTION
The user should make the following inspections at
least once each month during the heating season
and once just before
VSPH boilers maybe installed and vented either
as direct-vent boiler, which all air for combustion is
obtained directly from outside through the air intake
piping or as non-direct-vent boiler, which all air for
combustion is taken from inside the boiler room.
Typical direct-vent installations are shown on FIgures
2 and 3. Non-direct-vent installation is shown on Fig-
ures 4, 5 and 6.
1. VENTING AND AIR INTAKE SYSTEM REGULAR
INSPECTION
Inspect the system regularly for condensation, corrosion
and/or physical damage. A qualified professional should
service the boiler annually and include such an inspec-
tion at that time. The homeowner should look over the
system monthly for damage, water stains, any signs of
rust, other corrosions or separation of the vent and air
intake piping (if direct-vent).
Figure 2.
cold weather starts.
Figure 3.
Should an inspection turn up signs of condensation, cor-
rosion or damage, the boiler should be shut down immedi-
ately and the condition should be corrected by a qualified
professional.
If the boiler is vented horizontally through the wall, the out-
side termination, louvers and screen should be checked
for any debris blocking the opening and cleaned as
required.
V
ICTORY VSPH Models