Appendix
Indicator
LAN speed
3
indicator
I
Note on the onboard LAN controller
The separate management LAN connector is used as a management
interface (iRMC S4) and is prepared for operation with the Remote
Management. Optionally LAN connector 1 can also be used for iRMC S4
server management.
17.2.1.5 PSU indicator (only hot-plug PSUs)
Figure 318: PSU indicator
Indicator
PSU
1
operating
status
410
Status
yellow on
green on
off
Status
green on
green flashing
orange on
orange flashing
Upgrade and Maintenance Manual
Description
traffic a transfer rate of 1 Gbit/s
traffic a transfer rate of 100 Mbit/s
traffic a transfer rate of 10 Mbit/s
Description
Server is switched on and functioning
properly
Server is switched off, main voltage is
present (Standby mode)
PSU failure (over / under voltage, over
temperature or fan failure)
Overload warning
TX2540 M1