Mounting Thermostat On Wallplate; Using Thermostat Keys - Honeywell TRADELINE T7200D Installation Instructions Manual

THERMOSTAT
X Y
COMPRESSOR
CONTACTOR
1 POWER SUPPLY. PROVIDE DISCONNECT MEANS AND
OVERLOAD PROTECTION AS REQUIRED.
Fig. 5. Typical hookup of T7200E in single-stage heat
pump system.

Mounting Thermostat on Wallplate

The thermostat mounts on the wallplate after it is installed.
1. Engage the tabs at the top of the thermostat and
wallplate. See Fig. 6.
2. Press the lower edge of the case to latch.
NOTE: To remove the thermostat from the wall, first pull
out at the bottom of the thermostat; then remove
the top.
SETTINGS

Using Thermostat Keys

The thermostat keys are used to:
• set current time and day,
• program times and setpoints for heating and cooling,
ENTER OCCUPIED
PROGRAM MODE
RETURNS TO
NORMAL
OPERATIONS
SET OVERRIDE
Temporary
TEMPERATURE
OFFSET AND
ACTIVATE
Continuous
TEMPORARY
Unoccupied
OVERRIDE
ENTER HOLD MODE
T7200D,E SERIES 2000 COMMERCIAL MICROELECTRONIC THERMOSTATS
G O
COOL
CHANGEOVER
VALVE
FAN
RELAY
1
ENTER UNOCCUPIED
PROGRAM MODE
SET CURRENT DAY OR
PROGRAM DAY
Mon
Occupied
System
Heat
Set Program
Run Occupied Unoccupied
Program Start Time Start Time
Set Current Clear
Occupied Day/Time Start Time
SET CURRENT
DAY AND TIME
CLEAR PROGRAM PERIOD
Fig. 7. Thermostat key locations and descriptions.
• override the program temperatures,
• display present setting,
R
• set system and fan operation,
• configure Installer Setup,
• check Installer System Test.
See Fig. 7 for thermostat key information.
A.
ENGAGE TABS AT TOP OF THERMOSTAT AND SUBBASE OR WALLPLATE.
L1
(HOT)
L2
M4943A
B.
Fig. 6. Mounting thermostat on wallplate.
SET OCCUPIED
TEMPERATURE
SETPOINTS
AM
Room
Fan
Auto
Set Temperature
Occupied Unoccupied
Day Temp
Copy
System
SELECT
SYSTEM
OPERATION
COPY ONE
PROGRAMMED DAY
TO ANOTHER DAY
3
PRESS LOWER EDGE OF CASE TO LATCH.
SET UNOCCUPIED TEMPERATURE
SETPOINTS AND SCROLLS
THROUGH INSTALLER SETUP
AND SYSTEM TEST
Change
Time/Temp
Temp
Heat/Cool
Settings
Fan
SELECT FAN
CHANGE BETWEEN HEATING
OPERATION
AND COOLING SETPOINTS
AND SCROLLS BACKWARDS
THROUGH INSTALLER SETUP
NUMBERS AND SYSTEM TEST
M4824A
INCREASE
TEMPERATURE
OR TIME SETTING
DECREASE
TEMPERATURE
OR TIME SETTING
M10233A
62-0128—2