Thermostat Information - Honeywell TRADELINE T7200D Installation Instructions Manual

T7200D,E SERIES 2000 COMMERCIAL MICROELECTRONIC THERMOSTATS

Thermostat Information

1. Press the Heat/Cool Settings key to access the
thermostat information.
2. Press the increase
date code. The first two large digits are the month
and the third digit is the last digit of the year.
(Example: 036 = March 1996).
3. Press the increase
software identification code. (Example: 02 =
software ID code 2).
4. Press the increase
software revision number. (Example: 001 = revision
number 1).
62-0128—2
M4934
key to display the production
M4931
key again to display the
M4932A
key again to display the
M10229
5. Press the increase
EEPROM identification code. (Example: 314 =
EEPROM ID 314).
6. Press the increase
wallplate identification code. (Example: HP = heat
pump wallplate).
7. Press Run Program to exit the system test. The
system test times out after four minutes without any
key presses.
Setting Keypad Lockout Switch
The dip switch 1 on the back of the thermostat activates
the Installer Setup lockout feature. The switch must be set
to the ON position (up) to activate the lockout feature. See
Fig. 12. The factory setting is off (down). Remove the
thermostat from the wallplate and set the switch to ON if
keypad lockout is desired. The level of lockout is deter-
mined by the Installer Setup number 40.
BACK OF THERMOSTAT
Fig. 12. Set Installer Setup lockout dip switch 1
on back of thermostat.
8
key again to display the
M4933A
key again to display the
M10290
ON
1
2
1
2
1 DIP 1 IS ON
2
DIP 2 IS NOT USED.
M10235