Sharp AR-M160 Service Manual page 36

Main Sub
Contents
code code
26 05 Count mode setting
06 Destination setting
07 Machine condition check (CPM)
18 Toner save mode setting
30 CE mark conformity control ON/
OFF
31 Auditor mode exclusive setup
36 Cancel of stop at maintenance life
over
37 Cancel of stop at developer life
over
When any key input is made, it is displayed on the display section. When the [START] key is pressed,
the set code data are acquired and stored to the count mode set variable and in the EEPROM, and
the machine goes into the sub code input standby mode. However, if the [START] key is pressed
outside the set range, it is not assured. At that time, when the [Interrupt] key is pressed, the data are
not rewritten and the machine goes into the sub code input standby mode. When the [CA] key is
pressed, the simulation is terminated without rewriting the data.
[*1 : Total counter / Developer counter
0: *1= Double count
1: *1= Single count
2: *1= Double count
3: *1= Single count
When this simulation is executed, the current set destination code number is displayed. Enter the
desired code number of the destination and press the [START] key to set the destination.
Code number
0
1
2
3
4
5
6
If this setting is changed, SIM46-19 setting is also changed accordingly.
(The paper size is also changed: AB series is changed to A4, and Inch series to Letter.
The AE limit setup is set to the default.
When the destination is changed (from Japan to EX Japan or from EX Japan to Japan),
the maintenance cycle is also set to the default accordingly.)
When this simulation is executed, the current setting of the machine is displayed.
7-seg display
15
16
20
Used to set ON/OFF of the toner save mode.
Code number
0
1
* The toner save mode of the user program is also changed accordingly.
When this simulation is executed, the current set code number of CE mark conformity is displayed.
Enter the desired code number of CE mark conformity and press the [START] key to set the code
number.
Code number
0
1
Used to set whether the manual fed tray can be used or not when the auditor mode is set to the coin
vendor mode.
Code number
0
1
* When this is set to "Exclusive setup ON," if the auditor is set to the coin vendor mode and the
standard tray is set to the manual feed tray, the standard tray must be set to the main cassette.
Used to set stop at maintenance life over.
Code number
0
1
When this simulation is executed, the current set code number is displayed. Enter the desired code
number and press the [START] key to set the code number. The machine goes into the sub code
input state.
Code number
0
1
AR-M205 SIMULATIONS 7-9
Details of operation
*2 : maintenance counter]
*2= Double count
*2 = Double count
*2= Single count
*2= Single count
Destination
Japan AB series
Inch series
EX Japan AB series
EX Japan inch series
EX Japan AB series (FC)
China (EX Japan AB series + China paper support)
Taiwan (EX Japan AB series + China paper support)
Meaning (CPM information)
15CPM
16CPM
20CPM
Setting
Toner save OFF
Toner save ON
Setting
CE mark conformity control OFF
CE mark conformity control ON
Setting
Exclusive setup OFF (Manual paper feed allowed)
Exclusive setup ON (Manual paper fed inhibited)
Setting
Stop at maintenance life over
Cancel of stop at maintenance life over * Default
Setting
Stop at developer life over
Cancel of stop at developer life over
*Default for 100V system