Remote Controller; Battery Installation - Kenwood DNX7180 Quick Start Manual

Return to the Top page
Remote Controller Operation
R
emote Controller
This unit can be operated using the remote controller.
For , DNX6980, and DNX6480BT, the remote controller is supplied with the unit.
For DNX6180, DNX6040EX, and DNX5180, the remote controller is the optional accessory (RC-
DV331).
2CAUTION
• Put the remote controller in a place where it will not move during braking or other operations. A
dangerous situation could result, if the remote controller falls down and gets wedged under the
pedals while driving.
• Do not leave the battery near fire or under direct sunlight. A fire, explosion or excessive heat
generation may result.
• Do not recharge, short, break up or heat the battery or place it in an open fire. Such actions may cause
the battery to leak fluid. If spilled fluid comes in contact with your eyes or on clothing, immediately
rinse with water and consult a physician.
• Place the battery out of reach of children. In the unlikely event that a child swallows the battery,
immediately consult a physician.

Battery Installation

If the remote controller operates only over shorter distances or does not operate at all, it is
possible that the batteries are depleted.
In such instances, replace the both batteries with new ones.
1
Insert two "AAA"/"R03"-size batteries with the
following the illustration inside the case.
90 90
and poles aligned properly,