Kenwood DNX7180 Quick Start Manual page 25

DNX7180/DNX7480BT/DNX6980/DNX6180/DNX6040EX/DNX6480BTIDNX5180
GPS antenna
GPS antenna is installed inside of
the car. It should be installed as
horizontally as possible to allow easy
reception of the GPS satellite signals.
To mount the GPS antenna inside
your vehicle:
1} Clean your dashboard or other
surface.
2} Peel the backing off of the
adhesive on the bottom of the
metal plate (accessory
3} Press the metal plate (accessory
@)
down firmly on your
dashboard or other mounting
surface. You can bend the metal
plate (accessory
a curved surface, if necessary.
4} Place the GPS antenna (accessory
@)
on top of the metal plate
(accessory @).
&
• Depending on the type of car, reception
of the GPS satellite signals might not be
possible with an inside installation.
• The GPS antenna should be installed at
a position that is spaced at least 12 inch
(30 cm) from cellular phone or other
transmitting antennas. Signals from the
GPS satellite may be interfered with by
these types of communication.
• Painting the GPS antenna with (metallic)
paint may cause a drop in performance.
@).
@) to conform to
-25-
Microphone unit
lillED~
1} Check the installation position of
the microphone (accessory
2} Remove oil and other dirt from
the installation surface.
3} Install the microphone.
4} Wire the microphone cable up to
the unit with it secured at several
positions using tape or other
desired method.
Fix a cable with a commercial item of tape.
Peel the release coated paper of
double-face adhesive tape to fix on
the place shown above.
:
Adjust the direction of the
microphone to the driver.
@).
Continued