MTD 700 Series Professional Shop Manual page 169

FOR DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
Proper alignment of belt keeper
Replacing the left brake assembly
Left brake assembly
Brake components
www.mymowerparts.com
Figure 8.28
Figure 8.29
Figure 8.30
NOTE: Make sure the rod belt keeper is properly aligned
over the belt and the belt is not rubbing on the
keeper during reassembly. See Figure 8.28.
1. Remove the cutting deck from the rider as described
earlier in the chapter.
2. Note the layout or orientation of all the components
as you work on the deck.
3. Remove the extension spring to release tension on
the idler pivot bracket.
4. In this example you can replace the left side brake
assembly by removing the hex cap screw and nut
that secures the brake assembly to the deck. See
Figure 8.29.
NOTE: Note the proper order of the parts as you remove
them. See Figure 8.30.
5. Install the new brake assembly by reversing the dis-
assembly process.
.
Cutting Decks
163