Page 2
Datalogic representative. Electronic versions may either be downloadable from the Datalogic website (www.scanning.datalogic.com) or provided on appropriate media. If you visit our website and would like to make comments or suggestions about this or other Datalogic publications, please let us know via the "Contact Datalogic" page.
Table of Contents Quick Reference..................1 Labeling and Nomenclature ..............1 Installation ....................2 Power Supply ..................3 How to Scan ....................3 Troubleshooting..................4 Productivity Index Reporting™ Option..........5 Scanner Push Button ..............5 LED and Beeper Indicators..............7 Error Codes ....................9 Going Green.....................
Page 5
Datalogic Product, you will be deemed to have accepted the terms and conditions of this Agreement. If you do not intend to be bound to the terms of this Agreement, Datalogic is not willing to license the Software to you, you may not use the Datalogic Product or the Software, and you must contact the party from whom you acquired the Datalogic Product for instructions.
Page 6
Agreement or the granted licenses, but instead may elect to notify End User that End User is deemed to have ordered and accepted a license for each breaching use. End User shall pay Datalogic the applicable list price for such licenses as of the date of such breach.
Page 7
Datalogic Scanning Holdings, Inc., Legal Depart- ment, 959 Terry Street, Eugene, OR 97402. In the defense or settlement of any such claim, Datalogic may, at its option, 1) procure for End User the right to continue using the Datalogic Product, 2) modify the Datalogic Prod-...
Page 8
Notice. All notices required or authorized under this Agreement shall be given in writing, and shall be effective when received, with evidence of receipt. Notices to Datalogic shall be sent to the attention of Contract Administration, Datalogic Scanning Holdings, Inc., 959 Terry Street, Eugene, OR 97402, or such other address as may be specified by Dat- alogic in writing.
Use this guide to quickly complete your installation and begin using your scanner. For more details, including programming information, reference the Product Reference Guide (PRG), which is available for viewing and download from the Datalogic website listed on the back cover of this manual. Labeling and Nomenclature Figure 1.
Installation Connect the scanner to the host (terminal) using the interface (I/ F) cable as shown in . A cable from an older existing instal- Figure 2 lation can be re-used if it uses Power Off the Terminal (POT), unless it is a USB POT cable. If external power is used/needed, plug the AC Adapter into the AC wall outlet, then connect it to the I/F cable as shown in ‘b’...
Power Supply Models require either a Listed class II or class III with a Limited Power Source (LPS). For the safety certification to be valid, class III input power sources must be IEC/EN60950-1 (EN 60335- series, EN 60065 or relevant) approved. Input: 100 - 240 VAC Output: 12 VDC Max.
If the scanner still does not function properly, consult the Product Reference Guide (PRG) or contact your local supplier or Datalogic Customer Support Services. a. Reading of the various bar code symbologies can be independently enabled or disabled in the scanner.
Productivity Index Reporting™ Option Your scanner may be equipped with the optional Productiv- ™ ity Index Reporting feature. This feature allows for data collection on the readability index of bar codes scanned by the scanner. This data may be transmitted to the POS Ter- minal where it may be easily sorted for action by the MIS department to improve bar code quality at the front end.
Page 14
Table 1. Scanner Push Button Functions PRESS FUNCTION COMMENT DURATION Press the push button momen- tarily to increase speaker vol- ume. When the loudest volume is reached, a repeated press of Momentary (when Increments volume the push button cycles volume scanner is awake) back to the lowest setting, then volume increases on subsequent...
LED and Beeper Indicators The scanner’s beeper sounds and its green LED indicator illumi- nates to indicate various functions or errors on the scanner. The tables below list these indications. An exception to the behaviors listed in the tables is that the scanner’s functions are programma- ble, and may or may not be turned on.
Page 16
Table 2. Green LED Indications INDICATION COMMENT INDICATION Varies (see Error The LED can provide diagnostic feed- Codes on page 9 Diagnostics back if the scanner discovers a prob- for more informa- lem during SelfTest. tion) See Host Disable Prog. Mode The scanner is in Programming Mode.
Error Codes If an error is detected, the scanner will sound a long low tone (for three seconds) and flash its LED, indicating a failure. When this occurs, press the Scanner Push button to hear the error code. If it is configured to do so, the scanner will sound a series of beeps corresponding to the error code and/or flash its LED simultane- ous to the beeps.
Going Green Thank you for using the bar code mask on the opposite side of this page. This manual has been formatted to minimize the quantity of pages needed to provide all of the program- ming bar codes available for this product. Quick Reference Guide...
Bar Code Mask Cut a hole in this page and remove it from the manual as indicated to create a sleeve through which bar codes (start- ing on the following page) can be individually viewed and scanned. It is important that only one bar code at a time be presented to the scanner.
Programming Upon completing the physical connection between the reader and its host, proceed directly to the Programming Bar Codes table below to locate the interface type the reader is connected to (for example: RS-232, Keyboard Wedge, USB, etc.). Use the Bar Code Mask on the preceding page to isolate the bar code you intend to scan.
Page 22
START / END IBM 4683 Port 5B IBM 4683 Port 9B IBM 4683 Port 17 USB-OEM Magellan 3300HSi...
Page 23
START / END USB Keyboard USB COM Interface Keyboard Wedge A (PC/XT w/alternate Key Encoding) If other than Keyboard Wedge A with USA keyboard is needed, see the PRG or On Screen Programming for additional options. NOTE Quick Reference Guide...
FCC Statement This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion.
Warranty Datalogic warrants to Customer that this product will be free from defects in materials and workmanship for a period of 3 years from product shipment. In order to obtain service under this Warranty, Customer must notify Datalogic of the claimed defect before the...
Page 26
Datalogic. Datalogic shall assume risk of loss or damage for product in Datalogic's possession or product being returned to Customer by Datalogic, except such loss or damage as may be caused by the negligence of Customer, its agents or employees. In the absence of...
Page 27
EUROPEAN DECLARATION OF CONFORMITY Datalogic hereby declares that the equipment specified below has been tested and found compliant to the following directives and standards. Apparatus: Magellan® 3200VSi/3300HSi Omni-directional Imaging Scanners EU Directives: EMC 2004/108/EC Low Voltage 2006/95/EC RoHS 2002/95/EC WEEE 2002/96/EC...