Setting Up The Base And Charging Cradle (If Included); Connecting The Base - Gigaset C610 Manual

Hide thumbs Also See for C610:

Table of Contents

Setting up the base and charging cradle (if included)

The base and charging cradle are designed for use in enclosed dry rooms with a

temperature range of +5°C to +45°C.

Install the base on a level, non-slip surface in a central location in your house or

flat or mount the base or charging cradle on the wall

Please note

Pay attention to the range of the base.

This is up to 300 m in unobstructed outdoor areas and up to 50 m inside build-

ings. The range is reduced when Eco Mode (

The phone's feet do not usually leave any marks on surfaces. However, due to the

multitude of different varnishes and polishes used on today's furnishings, the

occurrence of marks on the surfaces cannot be completely ruled out.

Please note:

Never expose the telephone to the influence of heat sources, direct sunlight or

other electrical devices.

Protect your Gigaset from moisture, dust, corrosive liquids and vapours.

First connect the tel-

ephone jack

insert the cables into

the cable ducts.

Then connect the

mains adapter 1.

Please note:

The mains adapter must always be connected, as the phone will not operate

without a mains connection.

Only use the mains adapter and phone cord supplied. Pin connections on tele-

phone cables can vary (pin connections

and

page 77.

page 52) is activated.

page 72).

First steps

Table of Contents