Handsfree Mode; Switching To Mute - Gigaset C610 Manual

Making calls
However, if the caller's number is not
displayed, this can be due to the
following:
u
You have not ordered CLIP from your net-
work provider or
u
Your telephone is connected via a PABX
or a router with an integrated PABX (gate-
way) that does not transmit all informa-
tion.
Is your telephone connected via a
PABX/gateway?
You can establish this by checking for an
additional device connected between your
telephone and house connection, e.g., a
PABX, gateway etc. In most cases, simply
resetting this device will remedy the situa-
tion:
¤
Briefly disconnect the mains plug of your
PABX. Re-insert the plug and wait for the
device to restart.
If the caller number is still not
displayed:
¤
Check the CLIP settings of your PABX and
activate this function if necessary. In the
user guide for the device, search for the
term "CLIP" (or an alternative term such
as "calling line identification", "phone
number transmission", "caller ID", ...).
If necessary, contact the device manufac-
turer.
If this does not resolve the problem, it is pos-
sible that your network provider does not
the CLIP service for this number.
Have you ordered the calling line
display service from your network
provider?
¤
Check whether your provider supports
calling line display (CLIP) and that the
function has been activated for you. If
necessary, contact your provider.
Additional information on this subject can
be found on the Gigaset homepage at:
www.gigaset.com/service
30

Handsfree mode

In handsfree mode, instead of holding the
handset to your ear you can put it down, for
example on the table in front of you. This
allows others to participate in the call.
Activating/deactivating handsfree
mode
Activating while dialling
~ d
Enter the number and press the
handsfree key.
¤
You should inform your caller before you
use the speaker function so that they
know someone else is listening.
Switching between earpiece and
handsfree mode
d
Press the handsfree key.
During a call, activate or deactivate hands-
free mode.
If you wish to place the handset in the base/
charging cradle during a call:
¤
Press and hold the handsfree key d
while placing the handset in the base.
For instructions on how to adjust the loud-
¢
speaker volume, page 60.

Switching to mute

You can deactivate the microphone in your
handset during an external call.
h
Press key to mute the handset.
The display shows Microphone
is off.
Press the key again to reactivate
the microphone.
Please note
If the telephone is muted, all keys except
the mute key h and the end-call key
a will not work.