Connecting The Base Station; Connecting The Charging Cradle (If Included); Setting Up The Handset For Use - Gigaset A130 Manual

Connecting the base station

¤
First connect the mains adapter
¤
Then connect the telephone jack
the cable ducts.
Please note:
◆
The mains adapter must always be connected, as the phone will
not operate without mains connection.
◆
Use only the mains adapter and phone cord supplied. Pin con-
nections on telephone cables can vary.

Connecting the charging cradle (if included)

2
1

Setting up the handset for use

The display is protected by a plastic film. Please remove the protective film!
Inserting the batteries and closing the battery cover
Warning
Use only the rechargeable batteries recommended by Gigaset Communications GmbH (
conventional (non-rechargeable) batteries as this could result in significant health risks and personal injury. For
example, the batteries could explode. The phone could also malfunction or be damaged as a result of using batteries
that are not of the recommended type.
¤
Insert the batteries with the polar-
ity in the correct direction.
The polarity is indicated in the battery
compartment.
1
.
2
and insert the cables into
¤
Connect the flat plug to the power
1
supply .
¤
Plug the mains adapter into the plug
2
socket .
3
A130/A230
If you need to disconnect the
plug from the charging cradle,
press the release button
disconnect the plug
¤
First insert the battery cover at the top a.
¤
Then press the cover
¤
To reopen the battery cover, grip into the cavity on the cas-
ing, then pull the battery cover in an upward direction.
2 1
3
and
4
.
¢
page 11), i.e. never use
until it clicks into place.
b
a
1
1
4
3
b