Using The Fingerprint Sensor - Toshiba Tecra S3 User Manual

Replacing the cap
The AccuPoint cap is an expendable item that should be replaced after
prolonged use. A spare AccuPoint cap is supplied with the computer.
1. To remove the AccuPoint cap, firmly pinch the cap and pull it straight
up.
2. Position a new cap on the peg and press it into place.
The peg is square, so be careful to align the cap's square hole with the
peg.

Using the Fingerprint Sensor

Fingerprint recognition is a feature that enrols your fingerprint information
into the computer and helps prevent unauthorized access by others. By
enrolling the ID and password to the fingerprint authentication device, it is
no longer necessary to input the password from the keyboard. Just by
swiping the finger against the fingerprint sensor, the following functions will
be enabled:
■
Logon to Windows and access a security-enabled homepage through
IE (Internet Explorer).
■
Files and folders can be encrypted/decrypted and third party access to
them prevented.
■
Disable the password-protected screen-saver when returning from
power-saving (standby) mode.
■
System boot authentication and Single Touch Boot feature.
■
Authentication of the User Password and Hard Disk Drive Password
when booting up the computer.
To "swipe" refers to the action of reading a fingerprint using the fingerprint
sensor.
User's Manual
Removing the AccuPoint cap
Operating Basics
4-3