Miele HS11 Operating Instrucktion page 38

en
+ / - foot controls (dia. 18)
Press and hold the + or – foot control
until the power setting you require lights
up green.
^ Press the + foot control to select a
higher setting.
^ Press the - foot control to select a
lower setting.
+ / – controls with AutoEco setting
(dia. 19)
When you switch your vacuum cleaner
on the energy saving "AutoEco" setting
is selected automatically.
^ Press the + control to change to
"Turbo", the highest power setting.
^ Press the - foot control to change to
"Min.", the lowest power setting.
The power setting which is currently
selected will light up white.
+ / - controls on the handle
(radio-operated) (dia. 20)
Press and hold the + or – button until
the symbol for the power setting you
require shows in the display on the
cleaner.
^ Press the + button to select a higher
suction power level.
^ Press the - button to select a lower
suction power level.
The LED will light up each time a button
is pressed on the handle.
38
Opening the air inlet valve (dia. 21, 22
+ 23)
(not on models with radio-controls on
the handle)
It is easy to reduce the suction power
for a short time, e.g. to prevent rugs or
other objects being sucked into the
vacuum cleaner.
^ Open the air inlet valve far enough to
reduce the suction power.
The floorhead will be easier to
manoeuvre. Close the valve when you
are ready to use full power again.
During vacuuming (dia. 24 + 25)
^ When vacuuming, pull the cleaner
behind you on its wheels. You can
stand it upright for vacuuming stairs
and curtains etc.
Warning: When vacuuming
especially fine dust, e.g. sawdust,
sand, plaster, flour, talcum powder
etc., electrostatic charges build up
naturally. Under certain conditions
these charges will be released. To
avoid the unpleasant effects of
these discharges, a metal inlay has
been incorporated into the
underside of the handle. Please
make sure that you keep your hand
in constant contact with this metal
strip during vacuuming.