Griddle Surface; Cleaning; Limited Calibration - Keating Of Chicago MIRACLEAN Service Manual

A. Griddle Surface
With proper care, the MIRACLEAN® surface and its
unique cooking properties will last for many years.
However, nicks or dents in the griddle surface may
cause the griddle surface to lift from the depressed
area. If nicks are close together, the surface may raise
and be torn when a spatula or scraper is used. Care
should be taken, as the damage done is irreparable.
See Figure 3-3 on page 4.
CAUTION: Damage done to the MIRACLEAN®
surface is irreparable and is not covered under Keating
Warranty.
B. Limited Calibration (Less than 15°F difference)
You will need: One standard flat blade screwdriver
One accurate griddle thermometer
1. Set thermostat to desired temperature (300°F
recommended).
2. Allow thermostat to cycle three times.
3. Locate "L" on front of griddle plate above
thermostat to be calibrated to locate thermostat
bulb position. Place thermometer on plate over
bulb half way toward rear of griddle.
Figure 4-1
Thermostat calibration with knob on
4. If calibration of griddle is found to be less than 15°F
off, simply loosen three dial plate retaining screws
(See Figure 4-1), rotate dial plate to match
thermometer reading and tighten screws.
NOTE: Calibration is not covered under warranty.

GRIDDLE SURFACE

With proper care, the MIRACLEAN® surface and its
unique properties will last for many years. However,
nicks or dents in the griddle surface may cause the
griddle surface to lift from the depressed area. If nicks
are close together care should be taken as the damage
done is irreparable. See figure 3-3 on page 4.

CLEANING

Proper care should be taken to fully clean the griddle
on a regular basis.
DISCONNECT ELECTRIC POWER
SOURCE BEFORE CLEANING.
A.
any grease build-up on the switches
and thermostat knobs.
NOTE: If grease gets into the body
of the switch or thermostat, it may
cause it to fail.
IF GREASE GETS INTO THE
BODY OF
THERMOSTAT, IT MAY CAUSE
POSSIBLE ELECTRICAL SHOCK.
B.
and sides of the cabinet should be
kept clean for sanitary reasons.
6
CONTROL PANEL - Clean
THE SWITCH
CABINET - The front, back
OR