Ricoh A-C2 Service Manual page 96

26 January, 2001
B004R111.WMF
To replace the scanner wire:
1. Front and rear scanner wire bracket [A] (! x1 ea.)
2. Tension spring [B]
3. Tension bracket [C] (! x1). Loosen and do not remove!
4. Remove wires, front and rear.
5. Attach the new wires.
NOTE: Illustration above shows the front wire.
6. Pass the wire through the pulleys as shown in the illustration, and then pass
the bead-end of the wire through the slot in the pulley.
7. Turn the pulley until you see the red mark on the wire. 2 turns and 6 turns (see
top illustration)
8. Without allowing the wire to loosen, tape the wire to the pulley.
9. Pass the wire through
10. Complete threading the wire:
11. Scanner wire bracket
[C]
!
.
" $ %
# #
&
(! x1)
3-19
[A]
[B]
#Tension spring#Screw
SCANNER UNIT
B004R112.WMF