Ricoh A-C2 Service Manual page 204

SERVICE PROGRAM MODE
SP5 Mode Number
5129* F Paper Size Selection
5131* Paper Size Type Selection
5150* By-Pass Wide Paper
Mode
5212* Page Stamp
3* Duplex Printout Right/Left
Position
4* Duplex Printout High/Low
Position
5302* 2* Set Time
5501* 1* PM Alarm Interval
Function and [Setting]
Selects the "F" paper size
[0~2 / 0 / 1 step]
0: 8" 13" (L)
1: 8½" 13" (L)
2: 8¼" 13" (L)
Selects the paper size (type) for both originals
and copy paper.
[0~2 / DIP SW setting / 1 step]
0: Japan
1: North America
2: Europe
After changing the setting, turn the copier off and
on. If the paper size of the archive files stored on
the HDD is different, abnormal copies could
result.
Determines whether the transfer sheet from the
by-pass tray is used or not.
0: Off, 1: On
Normally the length for sub scanning paper from
the by-pass tray is limited to 600 mm, but this can
be extended with this SP to 1260 mm.
Determines how horizontal printing is executed
during duplex printing. Sets the upper right corner
of the front side and the upper left corner of the
backside so the starting points for horizontal
printing are the same on both sides DFU.
[–10~+10 / 0 / 1 mm step]
–10: Extreme right
+10: Extreme left
Determines how vertical printing is executed
during duplex printing. Sets the upper right corner
of the front side and the upper left corner of the
backside so the starting points for vertical printing
are the same on both sides. DFU
[–10~+10 / 0 / 1 mm step]
–10: Extreme top
+10: Extreme bottom
Adjusts the RTC time setting for the local time
zone.
[–1440~+1440 / 1 min. step]
Example: For Japan (+9 GMT), enter 540 (9
hours x 60 min.)
Sets the PM alarm interval.
[0~255 / 0 / 1 step]
0: Alarm off
1~255: Alarm goes off when
Value (1~255) x 1000
5-30
19 January, 2001
PM counter