HP StorageWorks 1/8 User's And Service Manual page 149

Event code Description
44 SCSI: flash image does not fit bootcode
45 SCSI: media removal prevented by drive
46 SCSI: media removal prevented by library
47 SCSI: flash image does not fit personality
48 SCSI: tape drive not supported by this library
SCSI: incompatible magazine, magazine not
49
accessible
4A Source not ready
4B Destination not ready
4C Reservation failed
4D Library controller busy
4E Invalid robotic request
4F Robotic not initialized
51 Incompatible medium
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide
Details and Solution
Check the version of firmware used for the
upgrade. The firmware is incompatible with
this device.
The application software has locked media
removal and either the software or device
user interface attempted to remove the media.
NOTE:
This IS NOT a hardware issue.
If the issue cannot be resolved with the
application software, power off the device,
disconnect the data cable, and then power
on the device.
Check the firmware file used for the upgrade.
The firmware is incompatible with this device.
The tape drive is not supported by the
firmware in this device. Upgrade the device
firmware to the most up-to-date version. Verify
that the drive has an HP MSL-G3 or 1/8 G2
firmware revision. If firmware is not the
correct type, the wrong tape drive has been
installed. Use only HP-approved support to
insure that the correct tape drives are used.
Verify that a supported magazine for that slot
is inserted. If the magazine is in the lower left
position, verify that the type of magazine is
consistent with the mailslot configuration.
• Retry the operation.
• Retry the operation.
The application software made an illegal
request.
Retry the operation.
• Verify that the drives are installed cor-
rectly.
• Verify that the cartridge and tape drive
generation are compatible. See
ward read compatibility" on page 47.
• Verify that the tape is correct for the oper-
ation initiated.
Back-
149