Pioneer DJM-800 Service Manual page 143

5
1. Starting the program
Click on Start, and select Program, Renesas, Flash
Development Tool Kit 3.1, then Flash Development Tool Kit
3.1.
When the program starts, the following message will be
displayed.
Click on OK.
Then the window shown below will be displayed.
Select Open a recent project workspace then click on OK.
5
6
The workspace will open.
To change the port where the RS-232C jig is to be
connected, modify the setting in the following way (if the
port does not need to be changed, skip to "2. Selecting the
.mot file to be downloaded into the DJM-800(efx1000)"):
Click on the Configure Flash Project icon.
The Flash Properties window will be displayed.
Click on the Communications tab. The screen shown below
will be displayed. Click on Port.
DJM-800
6
7
7
8
A
B
C
D
E
F
143
8