5
How to start the Test Mode.
To enter test mode, turn the Power button while pressing all of the HARMONIC,
FADER START CH1,CUE CH1 buttons.
There are 11 modes in this Test Mode.
If the TAP button is pressed, Mode1 ~ 11 can be selected by selector switch.
When set up mode is started, Mode 1 is selected automatically.
Once Test Mode starts, it keeps the test mode until turning the Power off.
Test mode Contents.
1 Mode 1 : Confirmation of software version.
Mode that confirms version of microcomputer, DSP (program), DSP (data), and FPGA.
It is displayed a version of firmware by FL display.
For exsample
Microcomputer : 1.000
DSP (program) : 1.000
2 Mode 2 : ALL LED & FL display "OFF" MODE. "ALL CLR"
It displays "ALL CLR" on the FL display in the first 2 seconds.
3 Mode 3 :
ALL LED & FL display "ON" MODE. "ALL SET"
It displays "ALL SET" on the FL display in the first 2 seconds.
5
6
M 1.000
D 1.000
DJM-800
6
7
7
8
A
B
C
D
E
F
125
8