Installing The Batteries - Targus PAWM10 User Manual

Using the RF Mouse

Installing the Batteries

1 If the mouse is on, slide the on/off switch on the bottom of
the mouse to the "off" position.
2 Remove the battery cover from the top of the mouse by
pressing the battery cover hinge located on the bottom of
the mouse and sliding it off.
NOTE: The battery cover is also the top cover of the mouse.
3 Insert the supplied batteries, making sure that the positive
(+) and negative (-) ends of each battery match the polarity
indicators inside the battery housing.
WARNINGS: When replacing the batteries, you may use
alkaline or other heavy-duty NiMH batteries. Never use an
alkaline with a NiMH battery in a device.
Avoid mixing new and used batteries in a device.
4 Slide the battery cover back into position until it "clicks"
firmly into place.
5 Turn on the mouse be sliding the on/off switch on the
bottom of the mouse to the "on" position.
The optical sensor, located on the bottom of the mouse,
glows red.
Targus Wireless RF Mouse
5