Installing The Batteries; Establishing The Connection - Targus STOW-N-GO User Manual

Targus Wireless Stow-N-Go Optical Mouse
TM

Installing the Batteries

1. Remove the battery cover from the back of the mouse by sliding off the
cover of the mouse. Hold the mouse in your hands and with the back of
the mouse away from you. Press down on the corners of the battery
cover and slide towards the back of the mouse. Lift the cover off from
the back of the mouse.
2. Insert two AAA-size batteries, making sure that the positive (+) and
negative (-) ends of each battery match the polarity indicators inside the
battery compartment. To replace the battery cover, place the cover on
top of the mouse and slide forward until it clicks into place.
4
Targus Wireless Stow-N-Go
TM

Establishing the Connection

(A) Remove the USB receiver from the bottom of the mouse.
(B) Plug the USB receiver into an available USB port on your computer.
This mouse is a plug and play device. It should automatically operate when
the USB receiver is connected to the computer.
5
Optical Mouse