Installing The Batteries - Targus AMW584 User Manual

(UG) AMW584GL-50_410-4169-001A
Targus AMW584 Bluetrace Wireless Mouse

Installing the batteries

Step 1: Take the battery cover off.
Step 2: Insert the batteries as shown inside the battery compartment.
Step 3: Replace the cover.
Step 4: Turn on power switch.
Warning:
Please insert the battery with the correct
position according to the instruction labeled
on the mouse.
Step 5: If you need to travel with your wireless mouse, made sure you turn off the POWER
SWITCH.
AA Battery X 2
3
folding line
2 staples here (saddle stitching)
Targus AMW584 Bluetrace Wireless Mouse
Setup the Connection between the Receiver and the Mouse
1. Insert the batteries into the mouse, then follow the steps below.
2. In the meantime, to open the mouse under the cover, take the
nano receiver out.
3. Plug the Nano receiver into the USB A port on your computer.
4. If the mouse does not work, please put it into pairing mode.
5. Pairing: Re-plug the receiver into the USB port on your computer, then press the connect button
on the mouse. If the mouse does not work after 10 seconds, pair them again. (The receiver has
auto pairing function).
6. The LED indicator on mouse flashes steadily when it is in pairing mode and stops blinking when
it is successfully paired with the receiver.
7. When low battery, the battery indicator on the mouse will start to blink.
4