Power Management Setup - Gigabyte GA-H67A-D3H-B3 rev. 1.0 User Manual

2-7

Power Management Setup

CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
ACPI Suspend Type
Soft-Off by PWR-BTTN
PME Event Wake Up
Power On By Ring
Resume by Alarm
x Date (of Month) Alarm
x Time (hh:mm:ss) Alarm
(Note)
HPET Support
(Note)
HPET Mode
Power On By Mouse
Power On By Keyboard
x KB Power ON Password
AC Back Function
ErP Support
: Move Enter: Select
F5: Previous Values
ACPI Suspend Type
S1(POS) Enables the system to enter the ACPI S1 (Power on Suspend) sleep state.
In S1 sleep state, the system appears suspended and stays in a low power mode.
The system can be resumed at any time.
S3(STR) Enables the system to enter the ACPI S3 (Suspend to RAM) sleep state (default).
In S3 sleep state, the system appears to be off and consumes less power than in the
S1 state. When signaled by a wake-up device or event, the system resumes to its
working state exactly where it was left off.
Soft-Off by PWR-BTTN
Instant-Off Press the power button and then the system will be turned off instantly. (Default)
Delay 4 Sec. Press and hold the power button for 4 seconds to turn off the system. If the power
button is pressed for less than 4 seconds, the system will enter suspend mode.
PME Event Wake Up
Allows the system to be awakened from an ACPI sleep state by a wake-up signal from a PCI or PCIe de-
vice. Note: To use this function, you need an ATX power supply providing at least 1A on the +5VSB lead.
(Default: Enabled)
Power On by Ring
Allows the system to be awakened from an ACPI sleep state by a wake-up signal from a modem that
supports wake-up function. (Default: Enabled)
(Note) Supported on Windows 7/Vista operating system only.
BIOS Setup
Power Management Setup
[S3(STR)]
[Instant-Off]
[Enabled]
[Enabled]
[Disabled]
Everyday
0 : 0 : 0
[Enabled]
[32-bit mode]
[Disabled]
[Disabled]
Enter
[Soft-Off]
[Disabled]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
- 48 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults