Gigabyte GA-H67A-D3H-B3 rev. 1.0 User Manual page 29

14) TPM (Trusted Platform Module Header)
You may connect a TPM (Trusted Platform Module) to this header.
15) CLR_CMOS (Clearing CMOS Jumper)
the CMOS values to factory defaults. To clear the CMOS values, place a jumper cap on the two pins to
temporarily short the two pins or use a metal object like a screwdriver to touch the two pins for a few
seconds.
Always turn off your computer and unplug the power cord from the power outlet before clear-
ing the CMOS values.
After clearing the CMOS values and before turning on your computer, be sure to remove the
jumper cap from the jumper. Failure to do so may cause damage to the motherboard.
After system restart, go to BIOS Setup to load factory defaults (select Load Optimized De-
Hardware Installation
19
20
Pin No.
1 LCLK
2 GND
3 LFRAME
4 No Pin
5 LRESET
6 NC
7 LAD3
8 LAD2
9 VCC3
10 LAD1
Open: Normal
Short: Clear CMOS Values
- 28 -
1
2
Pin No.
11 LAD0
12 GND
13 NC
14 ID
15 SB3V
16 SERIRQ
17 GND
18 NC
19 NC
20 SUSCLK