Lamp Replacement - LG BX27C-SL Owner's Manual

Maintenance and Cleaning

Lamp Replacement

When the projection lamp of the projector reaches its end
of life, the Lamp replacement icon appears on the screen
and LAMP REPLACE indicator lights yellow.Replace the
lamp with a new one promptly.The timing when the LAMP
REPLACE indicator should light is depending on the lamp
mode.
Lamp replacement
Lamp replacement icon
CAUTION
Allow a projector to cool for at least 45 minutes
before you open the Lamp Cover. The inside of
the projector can become very hot.
CAUTION
When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be
broken.
If replacing the lamp of a projector which has been installed on the ceiling, you should always assume that
the lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the
lamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get
into your eyes or mouth, seek medical advice immediately.
Follow these steps to replace the lamp.
1
Unplug the AC power cord. Let the projector cool for at
least 45 minutes.
2
Loosen the screw and open the lamp cover.
3
Loosen the two (2) screws that secure the lamp. Lift
the lamp out of the projector by using the handle.
4
Replace the lamp with a new one and secure the two
(2) screws. Make sure that the lamp is set properly.
Close the lamp cover and secure the screw.
5
Connect the AC power cord to the projector and turn
on the projector.
50
Top Control
CAUTION
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass
bulb! The glass can shatter and may cause injury.
Lamp Cover Screw
Lamp
Cover
Screw
LAMP REPLACE
indicator
Handles Screw
Lamp