Setup; Wireless System Setup; Hybrid Wired/Wireless System Setup; P2R Stand-Alone Wired Setup - Shure PSM200 User Manual

SETUP

Wireless System Setup

To configure the P2T TransMixer and P2R Receiver for wireless
operation:
1. Plug the power supply into the DC INPUT connector on
the rear panel of the P2T, then plug it into a power outlet.
2. Connect audio sources to the combo XLR/1/4-inch jacks
on the front panel.
3. Select a frequency channel (1-8). See the Selecting a Fre-
quency Channel section on page 6 for details.
IMPORTANT: Never set more than ONE TransMix-
er to the same frequency channel, or interference
will occur.
4. Observe the signal/clip LEDs. If they are consistently red,
decrease the level with the corresponding INPUT level
knob.

Hybrid Wired/Wireless System Setup

To configure the P2T TransMixer and P2R Receiver for hybrid wired/wireless operation:
1. Follow steps 1-9 of the Wireless System Set-Up section.
2. Connect an audio source to the 1/4-inch MIX IN jack on the side of the P2R.
3. Set the GAIN switch to LO initially and set the source volume to a moderate level.
4. Attach the P2R onto your belt, waistband, or another location.
5. Slide the audio cable or earphone cord into the cable management groove.
6. Slowly increase the P2R volume to a comfortable level. Set the GAIN switch to HI if you need more level.
P2R Stand-Alone Wired Set-Up*
To configure the P2R Receiver as a stand-alone personal monitor:
1. Turn the On/Off/Volume knob clockwise past click (On). Leave the vol-
ume setting low.
2. Set the CHANNEL to "A" with the SELECT Button. See the Wired Mode
section on page 8 for details.
3. Connect an audio source to the 1/4-inch MIX IN jack on the side of the
P2R.
4. Set the GAIN switch to LO initially and set the source volume to a
moderate level.
5. Attach the P2R onto your belt, waistband, or another location.
6. Slide the audio cable or earphone cord into the cable management
groove.
7. Plug the earphones into the earphone output jack. Insert the earphones
into your ears as instructed in the ear-phone user's guide.
8. Slowly increase the P2R volume to a comfortable level. Set the GAIN
switch to HI if you need more level.
NOTE: Setting the P2R receiver to "A" disables its wireless capability and extends the battery life.
* If you have purchased the P2R as a stand-alone personal monitor, you can go wireless by simply purchasing a P2T
TransMixer.
ENGLISH
MIC/LINE 1 MIC/LINE 2 1 INPUTS 2 CHANNEL
Mixing Console
9
5. To pass audio signal directly through the TransMixer,
use the corresponding SPLIT OUT connector on the rear
panel of the device.
6. Turn the On/Off/Volume knob on the P2R clockwise past
click (On). Leave the volume setting low.
7. Set the P2R to the same frequency channel as the P2T.
8. Check the RF LED on the P2R to confirm that transmis-
sion is being received.
9. Plug earphones into the earphone output jack. Insert the
earphones into your ears as instructed in the earphone
user's guide.
10. Slowly increase the P2R volume to a comfortable level.
PSM200 TransMixer
SELECT
Mixing Console