Table of Contents
Advertisement
Installing the Backplane
Installing the Backplane into the Chassis
1.
Ensure that all of the hard drive trays have been removed from the bays in
the front of the chassis and that the spring bar has been loosened as directed
in the previous section.
2.
Secure the side mounting bracket to the backplane with the two screws
provided.
3.
Slide the backplane into the chassis at a slight angle, pushing it up against
the side of the chassis.
4.
Ease the backplane forward, against the front of the chassis. This will aid in
the alignment of the mounting holes.
5.
Align the mounting holes in the backplane with the holes in the chassis.
Replace the four screws at the top of the backplane and the screw on the
side of the chassis.
6.
Adjust the spring bar, then tighten the spring bar screws in the fl oor of the
chassis.
7.
Replace the side screw in the side of the chassis
8.
Reconnect all cables and return the hard drive trays to their bays in the front
of the chassis.
2
1
Figure 6-9. Installing the Backplane
1
3
6-9
Chapter 6: Advanced Chassis Setup
4
1
Advertisement
Table of Contents
