Table of Contents
Advertisement
A+ SERVER 2022TG-HTRF/HIBQRF User's Manual
2-5
Checking the Serverboard Setup
After you install the 2022TG-HTRF/HIBQRF in the rack, you will need to open the
unit to make sure the serverboard is properly installed and all the connections
have been made.
Accessing the inside of the System
Before operating the server for the fi rst time, it is important to remove the protective
fi lm covering the top of the chassis, in order to allow for proper ventilation and
cooling.
Removing the Chassis Cover and Protective Film
1.
Remove the two screws which secure the top cover onto the chassis as
shown above.
2.
Lift the top cover up and off the chassis.
3.
Peel off the protective fi lm covering the top cover and the top of the chassis
4.
Check that all ventilation openings on the top cover and the top of the chassis
are clear and unobstructed.
Checking the Components and Setup
1.
You may have one or two processors already installed into the serverboard.
Each processor needs its own heat sink. See Chapter 5 for instructions on
processor and heat sink installation.
2.
Your 2022TG-HTRF/HIBQRF server system may have come with system
memory already installed. Make sure all DIMMs are fully seated in their slots.
For details on adding system memory, refer to Chapter 5.
3.
If desired, you can install add-on cards to the system. See Chapter 5 for
details on installing PCI add-on cards.
4.
Make sure all power and data cables are properly connected and not blocking
the chassis airfl ow. Also make sure that no cables are positioned in front of
the fans. See Chapter 5 for details on cable connections.
2-8
Advertisement
Table of Contents
