-
.
•
Your Detector "
Select/Dim Button
@- ....•
Program/Mute Button
@-
.
.......(!)
Set/City
Button
To Set the IntelliMute Activation Point Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode, go to Set
I
t
II'M
t
Tone
Visual Display
n e
I
u e.
None
Set IntelliMute
Press and release the Set/City button
Two beeps
Press SET at
to begin setting IntelliMute RPMs.
desired RPMs...
Rev your engine to the level you wish to None
None
set. Rev the engine slightly above idle and
hold revs steady for two seconds.
At the desired rev level, press and
Three beeps
IntelliMute Set!
release the Set/City button.
Press and release either the
None
None
Select/Oim button to proceed to the
next user mode or the Program/Mute
button to exit the Program mode.
Setting IntelliMute RPMs
(0)
NOTE
If the unit is unable to sense usable pulses
within three seconds or if you do not set a
rev point within 20 seconds of beginning
these steps, IntelliMute will indicate an
error and automatically turn Off.
Set Intel. ..
Press SET...
One beep
One beep
IntelliMute not set
Please try again
IntelliMute Off
IntelliMute
Not Set
IntelliMu .
Please
tr .
IntelliMute Off
Intelli
Mute
all
Nothing Comes Close to a Cobra-
~