Cobra XRS 9690 Operating Instructions Manual page 12

This EasySet Programming menu lists all of the modes and settings you can
choose from after you have entered Program mode as described on page 7.
(see page 14 rev pomt while usmg IntelllMute.
to set activation Note: Only shown if IntelliMute is Off.
IntellJMute
RPMs
Mode Tone Visual Setting
Result
Set Two beeps City X A single beep sounds when the
IntelliShield
I
signal is first detected.
City mode
One beep City X Audio for all X band alerts are blocked
default·
beep Off
until signal strength reaches Level 3.
One beep
City X+K
Combines the City X mode with
prevention of K band audio alerts
until signal strength reaches Level 2.
IntelliMute Two beeps IntelliMute On
All alerts (except for strobe signals
mode
from emergency vehicles) are
automatically muted below the
engine rev point you set.
One beep IntelliMute Off Normal operation.
set
One beep
Set IntelliMute
Allows you to set the engine
point) I
IntelliMute Two beeps
IntelliMute Pro
All radar, VG-2 and Spectre detection is
Pro mode On tumed Off below the engine rev set point.
One beep IntelliMute Pro Normal operation.
I
Off
I
AutoMute
Two beeps
AutoMute On
The audio volume of all alerts will be
mode
automatically muted after four seconds for
I
as long as the signal is detected.
One beep AutoMute Off
All alerts will sound at full volume
for as long as the signal is detected.
Set One beep
Set Compass
Allows you to calibrate the compass.
compass (see page 17 to calibrate compass)
Pop Detect Two beeps Pop Detect On
Unit will detect Pop signals.
mode
One beep Pop Detect Off Unit will not detect Pop signals.
~
English