Cobra XRS 9690 Operating Instructions Manual page 11

Three beeps
To Use Program Mode
Press and hold the
Program/Mute button
for two seconds.
..........$
set/City Button
Press and release
..$
selectlDim Button
Press and release
......... (!) ProgramIMute Button
Press and hold/Press and release
Program will appear.
PROGRAM
Then brief programming
instructions will scroll through
the display three times.
While the programming
instructions are
scrolling, press and
release the Select/Dim
button to cycle through
the user modes.
With the user mode you
wish to change displayed,
press and release the
SetICity button to
change the setting.
To move to the next
selection, press the
Select/Dim button again.
One beep with
each button press
One or two beeps,
depending on your
selection
As each mode is displayed,
the current setting for that
mode will be shown.
The setting you select will
be shown.
When you exit Program
mode, the new setting will
automatically be saved and
EXIT PROGRAM and Settings
Saved! will appear in the display.
When you have finished
programming any or
all of the user modes,
press and release the
Program/Mute button
to exit Program mode.
Or simply wait ten
seconds without
pushing any buttons.
One beep
EXIT
PROGRAM
Settings
Saved
I
Nothing Comes Close to a Cobra-
0