Unit ID Display for Switches in a Switch Stack
The Stack ID 7-segment LED (as shown below) on the front panel of the stacking module displays the logical
STACK NO. The Master Switch in the stack will display STACK NO. 1. The remaining slaves display the
STACK NO. 2 to 13 according to the position in the logical stack order.
Connecting Devices to the Switch
These connections can be accomplished at any port in either straight-through cable or a crossover cable because
the switch supports Auto-MDIX function.
NOTE: Auto-MDIX function is not supported by the 100BASE-TX module.
•
A 10BASE-T hub or switch can be connected to the switch via a two-pair Category 3, 4 or 5
UTP/STP cable.
•
A 100BASE-TX hub or switch can be connected to the switch via a two-pair Category 5 UTP cable.
•
A 1000BASE-T connections use two-pair Category 5e UTP cable.
D-Link DES-3326SR Layer 3 Switch
Figure 2 - 11. DES-3326SR Stacking Module Front Panel
NOTICE: Spanning Tree Protocol is disabled by default on the Switch.
Keep this in mind when connecting the Switch to the network.
28