Setting the Treble Control
Turning Loudness On/Off
You can change the Treble Frequency emphasis to create your own tonal
preference.
1
Press SOUND/SETUP repeatedly to select the
TREBLE mode.
BASS -) TREBLE -) Hf'F -) BASS
. '
~e~!f\g:t~@·lre,~I!,:(;;'~~!.~
. . .
F ~
..
q~~o~j')
2-1 Press BAND to select the desired treble center
frequency.
10.0 kHz
-~
12.5 kHz
-~
15.0 kHz -) 17.5 kHz -) 10.0 kHz
Emphasizes the displayed treble frequency ranges.
:1
Loudness introduces a special low- and high- frequency emphasis at low
listening levels. This compensates for the ear's decreased sensitivity to
bass and treble sound.
Press and hold Rotary encoder (LOUD) for at least 2
seconds to activate or deactivate the loudness mode.
• Thefunction is inoperable when DEFEAT is set
to
ON.
2-2,.2Turn the Rotary encoder to select the desired
treble level (-7-+7).
You can emphasize the treble level.
3
Press and hold
~/ESC
for at least 2 seconds to
return to normal mode.
• If
no operation is performed for
J
5 seconds, the unit will return to
normal mode automatically.
• The treble level settings will be individually memorized for each
source (FM. AM. CD, etc.) until the setting is changed. The Treble
frequency settings adjusted for one source are effective for all other
sources (FM. AM, CD. etc.).
• Thefunction is inoperable when DEFEAT is set to ON.
*2 The adjustmt'nt can also be made by pressing Rotary encoder.
Refer to "Adjusting Subwoofer Level/Bass LevellTreble Level/
Balance (Between Leji and Right)/Fader (Between Front and Rear)/
Defeat" (page
12).
Adjusting the High Pass Filter
The High Pass Filter on this unit can be adjusted to suit your personal
taste.
1
Press SOUND/SETUP repeatedly to select the HPF
mode.
BASS -) TREBLE -) Hf'F -) BASS
2
Turn the Rotary encoder to select the desired HPF
frequency.
OFF
H 60 Hz H 80 Hz H 100 Hz
All frequencies above tl1e selected cutoff are output.
3
Press and hold
~/ESC
for at least 2 seconds to
return to normal mode.
• [(no operation is performedJor 15 seconds. the unit will return
to
normal mode automatically.
• The Junction is inoperable when DEFEAT is set to ON.
13-EN