Starting The Engine; Preparation Before Starting - Honda Outboard Motor BF15A Owner's Manual

5. STARTING THE ENGINE
1. Preparation Before Starting
CAUTION: To prevent damage to the outboard from overheating, never
run the engine with the propeller out of the water.
1. Connect the fuel line to the.tank and outboard motor, as shown. Be sure
the connectors are securely latched.
mm
Be careful not to spill any fuel when refueling. Spilled fuel or fuel
vapor may ignite. If any fuel is spilled, make sure the. area is dry before
starting the engine.
NOTE:
l
Position the fuel tank so the tank fuel line connector is no more than 1
meter (3.3 ft) below the motor fuel line connector.
l
Do not place the fuel tank more than 2 meters (6.6 ft) away from the
motor.
l
Be sure that the fuel line is not kinked.
MALE FUEL LINE CONNECTOR
-TO FUEL TANK
-TO MOTOR
2. Open the fuel cap vent knob 2 to 3 turns.
3. Squeeze and release the primer bulb until it feels firm, indicating that
fuel has reached the motor. Check for leaks.
CAUTION: Do not use the primer bulb while the engine is running or you
may flood the engine by forcing too much fuel into the carburetor.
I
VENT KNOB
\
15