Assembly - CYBEX 8800 Owner's And Service Manual

Tools Required
•
7/32" Allen wrench
•
3/4" Socket
•
Hammer
•
3/16" Pin punch
•
9/16" Wrench
•
Loctite #242
NOTE: Two people will be required to perform this procedure.
NOTE: It is the responsibility of the facility owner/owner of the equipment to ensure that there is
appropriate clearance around each machine to allow for safe use and passage.
NOTE: Refer to Chapter 6 for reference diagrams.
1. Read and understand all instructions thoroughly before assembling this product.
2. Verify the appropriate confi guration was received:
A. Correct color of machine.
B. Proper weight stack and weight stack decals.
C. Appropriate owner's manual.
D. Warranty sheet.
E. Verify which machine was received 8800 (Chin-Up Bar Installed) or 8810 (With Chin-Up Bar).
3. Move to desired location.
NOTE: If machine is an 8800 and does not fi t through doorway proceed to step 10.
NOTE: If machine is an 8810 and does not fi t through doorway proceed to step 10J- 10P. Proceed to
step 13 to install Chin-Up Bar.
NOTE: If machine is an 8810 install Chin-Up Bar. Proceed to step 13 to install Chin-Up Bar.
4. Remove shipping pallet.
WARNING: Use extreme caution when removing shipping pallet.
Failure to do so could result in injury.
A. With an assistant, using a 9/16" wrench, carefully remove each lag bolt securing frame to
pallet.
B. Carefully place frame on fl oor.
Product Number 8800/8810 Owner's Manual

4 - Assembly

Assembly
Page 4-1