CYBEX 8800 Owner's And Service Manual page 24

More Diffi cult Stains
•
Dampen a soft white cloth with a solution of 10% household bleach (sodium hypochlorite),
90% water. Rub gently. Rinse with a water dampened cloth to remove bleach concentration.
•
The same procedure can be used with full strength household bleach, if necessary.
•
Allow bleach to puddle on the affected area or apply with a soaked cloth for approximately
30 minutes. Rinse with a water dampened cloth to remove any remaining bleach concentration.
Alternative Method for Diffi cult Stains
•
Dampen a soft white cloth with rubbing alcohol and rub gently. Rinse with a water dampened cloth to
remove any remaining rubbing alcohol concentration.
NOTE: To restore luster, a light coat of spray furniture wax can be used. Apply for 30 seconds and follow with a
light buffi ng using a clean white cloth.
Please Review Carefully
When using strong cleaning agents such as rubbing alcohol or bleach, it is advisable to fi rst test in an
inconspicuous area. Other cleaning agents may contain harsh or unknown solvents and are subject to formula
changes by the product manufacturer without notice. Should you desire to use other cleaning agents, carefully try
them in an inconspicuous area to determine potential damage to the material. Never use harsh solvents or
cleaners which are intended for industrial applications. To clean stained or soiled areas, a soft white cloth is
recommended. Avoid use of paper towels.
Cleaning products may be harmful/irritating to your skin, eyes, etc. Use protective gloves and eye protection. Do
not inhale or swallow any cleaning product. Protect surrounding area/clothing from exposure. Use in well
ventilated area. Follow all product manufacturer's warnings. CYBEX and its vendors cannot be held responsible
for damage or injuries resulting from the use or misuse of cleaning products.
2. Frames - Wipe down all frames using a mild solution of warm water and car wash soap. Be sure to dry
thoroughly. AVOID acid or chlorine based cleaners and also cleaners containing abrasives as these could
scratch or damage the equipment.
3. Chrome - Clean chrome tubes, fi rst using chrome polish and then using a car wax seal. Neutral cleaners with
a pH between 5.5 and 8.5 are recommended. Be sure to dry thoroughly. AVOID acid or chlorine based cleaners
and also cleaners containing abrasives as these could scratch or damage the equipment.
4. Guidelines for cleaning front panel:
•
Use clean soft cloths or sponges for application of cleaners and again for washing and rinsing.
•
Follow up the application with warm water rinse.
•
Don't use abrasives or high alkaline cleaners.
•
Don't leave cleaners on for long periods, wash immediately.
•
Don't apply cleaners in direct sunlight or at elevated temperatures.
•
Don't use scrapers, squeegees or razors.
•
Don't clean with gasoline.
Maintenance
Page 5-2
Product Number 8800/8810 Owner's Manual