Nvidia nF6100-400 User Manual page 15

Connectors
JCPU_FAN
1
JPWR_FAN
JSYS_FAN
2
FDD
IDE1
3
1
Primary IDE
PW1
4
3
4
+12V +12V
PW12
Ground Ground
1 2
Front Line-out-R
NC
Front Line-out-L
9
5
CFPA
10
NC
Key
CD-IN
6
1
CUSB3
7
CUSB4
CUSB5
Figure Descriptions
CPU / Power / Chassis Fan Power Connectors
JCPU_FAN:
Control Ground
Sense
JPWR_FAN:
+12V
JSYS_FAN:
Ground Sense
+12V
Floppy Drive Connector
1
Primary IDE Connector
Connects to the IDE device, i.e. HDD and CD-ROM device.
PW1:
PW12:
The plugs of the power cables are designed to fit in only one
orientation.
CFPA: Front Panel Audio Connector
NC
This audio connector connects to the audio jacks located on the
MIC_In
1 front panel. Refer to your case manual to match the pin-out
names.
2
NC GND
+5V
CD-IN: CD Audio-in connectors
CD_IN_Right
These connectors are used to receive audio from a CD-ROM
CD_Reference
drive, TV tuner or MPEG card.
CD_IN_Left
CUSB3~CUSB4: Four USB2.0 header from nF6100-400/
CUSB3~CUSB5: Six USB2.0 header from nF6100-430
This mainboard includes additional onboard USB ports.
To use these additional USB ports, a USB bracket is required.
Please contact your retailer for details.
Connect the CPU fan to this connector.
Use this connector if you are installing an
additional fan in the unit.
The chassis fan will provide adequate
airflow throughout the chassis to prevent
overheating the CPU.
When using two IDE drives on the same
connector, one must be set to Master mode
and the other to Slave mode. Refer to your
disk drive user's manual for details.
24-pin ATX Power Connector
4-pin ATX12V Power Connector
The PW1 and PW12 Power Connector must
be used simultaneously.
nF6100-405, or
Introduction
11