Table of Contents
Advertisement
Introduction
2-2 Jumper Settings
8
JCMOS: Clear CMOS data Jumper
If the CMOS data becomes corrupted or you forgot the supervisor or
user password, clear the CMOS data to reconfigure the system back to
the default values stored in the ROM BIOS.
To CMOS Clear data, please follow the steps below.
1. Turn off the system.
2. Change the jumper from "1-2" to "2-3" position for a few
seconds.
3. Replace the jumper back to the "1-2" position.
4. Turn on the system and hold down the <Del> key to enter
BIOS setup.
JUSB
: USB S3 Wake up Jumper
This jumper disconnects 5V standby voltage to USB devices.
This means USB devices will not be able to wake-up the system
from S3 (Suspend to RAM) power saving mode.
Settings:
1-2: Normal (Default)
2-3: Clear CMOS
Settings:
1-2: Enabled (S3 enabled)
2-3: Disabled (No S3)
Advertisement
Table of Contents
