(models without clamp screws)
WASHER
BOLT
WASHER
TRANSOM
BOARD
Attach the stern bracket to the boat
transom with good quality stainless
steel bolts, nuts, and washers. Apply
silicone sealant to the bolt holes.
TRANSOM ANGLE
ADJUSTMENT
LOCK NUT
Use the transom angle adjustment rod
(p.
41
) to adjust the angle of the
outboard motor so the propeller is
perpendicular to the surface of the
WASHER
water.
LOCK NUT
MOUNTING
HOLE
INSTALLATION
BATTERY CONNECTIONS
−
TO ACCESSORIES
BATTERY
Honda BF8D/BFP8D/BF9.9D/
BFP9.9D/BF15D/BFP15D/BF20D
and BFP20D outboard motors
produce a 12-volt, 6 or 12-ampere
battery-charging current and are
equipped for connection to a 12-volt
battery. The battery-charging circuit
is protected by a 20-ampere fuse
located in the engine compartment.
The outboard motor's 12-volt output
is intended for battery charging only.
Lights and electrical accessories for
the boat should be connected to the
battery.
35