HP Procurve 2650 Management And Configuration Manual page 97

N o t e
To save and
implement the
changes for all
parameters in this
screen, press the
key, then press
(for Save). To
cancel all changes,
press the key,
then press (for
Cancel)
N o t e
Using the Menu and Web Browser Interfaces To Implement Configuration Changes
The only exception to this operation are two VLAN-related parameter changes
that require a reboot—described under "Rebooting To Activate Configuration
Changes" on page 5-10.
Using and
Save Cancel
For any configuration screen in the menu interface, the Save command:
1. Implements the changes in the running-config file
2. Saves your changes to the startup-config file
If you decide not to save and implement the changes in the screen, select
Cancel to discard them and continue switch operation with the current oper-
ation. For example, suppose you have made the changes shown below in the
System Information screen:
Figure 5-4. Example of Pending Configuration Changes that Can Be Saved or
Cancelled
If you reconfigure a parameter in the CLI and then go to the menu interface
without executing a write memory command, those changes are stored only in
the running configuration. If you then execute a switch reboot command in
in the Menu Interface
Switch Memory and Configuration
5-9