Advertisement
SET UP AND USAGE INSTRUCTIONS
q Replacing the Spark Cartridge:
Friction during sparking will eventually wear out the replaceable cartridge and cause the scooter to stop making
sparks. Worn out cartridges must be replaced.
1
Using your thumbs, press tabs
on both sides of the cartridge to
release from the bracket. Slide car-
tridge away from you and remove
from bracket.
q Using the Spark Handle
1
Pull up on the handle to operate sparking feature.
2
Place a new cartridge in back of the bracket making sure to align the slots
on the cartridge with the two legs of the bracket. Slide cartridge forward
until you hear a click and the thumb tabs are locked in place.
NEVER push down directly on the Spark Bar, spark
cartridge or spark cartridge cover itself.
5
Meijer.com
WARNING: Do not
attempt to replace cartridge
immediately after riding as
cartridge will be hot. Handle only
when cool.
WARNING: Keep fingers
clear of Spark Bar hinge.
WARNING: Pulling
the Spark Handle upwards too
strenuously may cause loss of
control.
NOTE: Sparks and Spark
cartridge life will vary based on
the amount of pressure applied
by spark handle, the length of
time pressure is applied and
the smoothness of the riding
surface.
Advertisement
