How To Use Control Panel - Masterbuilt 20070710 Assembly, Care & Use Manual

HOW TO USE WOOD CHIP LOADER
Load
Unload
Load
Unload
When door is opened a flare up may occur. Should wood chips flare up, immediately close
door, wait for wood chips to burn down then open door again. Do not spray with water.
9
Pre-soak wood chips in water for at
least 30 minutes.
Before starting unit, place 1 cup of
wood chips in chip loader.
Never use more than 1 cup of
wood chips at a time. Never use
wood chunks.
Insert wood chip loader into smoker.
Wood chips should be level with top
rim of wood chip loader.
Turn handle to "Unload" mark on
smoker. Wood will drop onto wood
chip holder. Turn handle to "Load"
and leave wood chip loader in place
inside smoker.
Check wood chip holder periodically
to see if wood has burned down by
removing wood chip loader and
looking into smoker through hole.
Add more chips as needed.
Wood chip loader must be pulled out
completely from smoker when
checking wood chip level.
Adding more wood during
smoking process:
Caution: Keep smoker door closed
when adding wood chips.
Note: Wood chip loader will be HOT
even if handle is not.
To add wood, turn handle to "Load"
position on smoker.
Pull wood chip loader from smoker.
Place wood chips in wood chip
loader and re-insert into smoker.
Turn handle to "Unload" mark on
smoker. Wood will drop onto wood
chip holder.
Temperature may spike briefly after
wood is added. It will stabilize after
a short time. Do not adjust
temperature setting.
CAUTION

HOW TO USE CONTROL PANEL

Note: Direct sunlight may interfere with ability to read LED display, block light if needed.
To set temperature:
•Press ON button.
•Press SET TEMP button once-LED display will blink.
•Use +/- to set temperature.
•Press SET TEMP button again to lock in temperature.
Note: Heating will not begin until timer is set.
To set timer:
•Press SET TIME button once-LED display for hours will blink.
•Use +/- to set hours.
•Press SET TIME button again to lock in hours. The minutes LED will start blinking.
•Use +/- to set minutes.
•Press SET TIME to lock in minutes and start cook cycle.
Heat will turn off when time has expired.
10