Masterbuilt 20070710 Assembly, Care & Use Manual
Masterbuilt 20070710 Assembly, Care & Use Manual

Masterbuilt 20070710 Assembly, Care & Use Manual

Digital smokehouse
Hide thumbs Also See for 20070710:

Advertisement

Masterbuilt Manufacturing, Inc
1 Masterbuilt Court
Columbus, Georgia 31907
Customer Service 1-800-489-1581
ASSEMBLY, CARE & USE MANUAL
WARNING & SAFETY INFORMATION
MODEL 20070710 DIGITAL SMOKEHOUSE
THIS PRODUCT IS FOR OUTDOOR USE ONLY ~ HOUSEHOLD TYPE
Approximate assembly time: 10 minutes.
Tools required for assembly: Phillips Head Screwdriver.
CARBON MONOXIDE HAZARD
Burning wood gives off carbon
monoxide which can cause death.
DO NOT burn wood chips inside homes,
vehicles, tents, garages or any enclosed
areas.
Use only outdoors where it is well
ventilated.
Failure to follow these warnings and instructions properly could result in personal injury or death.
WARNING
This manual contains important
information necessary for the proper and
safe use of this unit.
Read and follow all warnings
and instructions before using
smoker and during use.
Keep this manual for future reference.
Some parts may have sharp edges handle
with care.

Advertisement

Table of Contents
loading

Summary of Contents for Masterbuilt 20070710

  • Page 1 Columbus, Georgia 31907 ASSEMBLY, CARE & USE MANUAL Customer Service 1-800-489-1581 WARNING & SAFETY INFORMATION MODEL 20070710 DIGITAL SMOKEHOUSE THIS PRODUCT IS FOR OUTDOOR USE ONLY ~ HOUSEHOLD TYPE Approximate assembly time: 10 minutes. Tools required for assembly: Phillips Head Screwdriver.
  • Page 2: Limited Warranty Information

    • Do not plug in electric smoker until fully assembled and ready for use. • Use only approved grounded electrical outlet. This expressed warranty is the sole warranty given by Masterbuilt and is in lieu of all other warranties, expressed or implied including implied warranty, merchantability, or fitness for a particular purpose.
  • Page 3 • Do not store electric smoker with HOT ashes inside unit. Store only when all surfaces are cold. • Accessory attachments not supplied by Masterbuilt Manufacturing, Inc. are not recommended and may cause injury. • The use of accessory attachments not recommended by the appliance manufacturer may cause injuries.
  • Page 4: Let's Get Started

    LET'S GET STARTED! LET'S GET STARTED! MASTERBUILT SMOKIN’ RECIPES SMOKED TROUT SMOKED STUFFED SALMON Servings for 4 Servings for 6 • This is a slow smoker…allow sufficient time for cooking. Smoker is for OUTDOOR USE ONLY. INGREDIENTS: INGREDIENTS: Trout fillets...
  • Page 5: Parts List

    Adjustable Screw Leg 990070018 Door Latch Kit 910050009 Leg Boot 9807090010 Instruction Manual 9907090040 Window Kit 9907090041 Door Hinge Kit 998060017 Hardware Kit DO NOT RETURN TO RETAILER STOP! For Assembly Assistance, Missing or Damaged Parts Call: MASTERBUILT Customer Service at 1-800-489-1581...
  • Page 6: Assembly

    ASSEMBLY INSTRUCTIONS MASTERBUILT SMOKIN’ RECIPES Tools required for assembly: Phillips Head Screwdriver. SMOKED PORK BUTT Servings for 6 tension nut Step 1 INGREDIENTS: Fresh Pork Butt 7 lbs (3.1kgs) Adjust feet by turning Salt clockwise/counter-clockwise so Brown sugar Chili Powder...
  • Page 7 IMPORTANT FACTS ABOUT USING SMOKER ASSEMBLY INSTRUCTIONS Continued • Maximum temperature setting is 275°F (135°C). • Wood chip loader and wood chip holder MUST be in place when using smoker. This minimizes the chance of wood flare ups. Step 3 Mount control panel by inserting •...
  • Page 8: Troubleshooting Guide

    See Step 2 on Page 5 connected to smoker Note: Wood chip holder and wood Controller malfunctioning Contact Masterbuilt at 1.800.489.1581 chip loader MUST be in place when Unit takes excessive amount of time to Unit plugged into an extension cord Set unit so an extension cord does not have to be using smoker.
  • Page 9 HOW TO USE CONTROL PANEL continued ASSEMBLY INSTRUCTIONS Continued SOME PARTS NOT SHOWN FOR CLARITY Light Step 7 Slide cooking racks onto guides inside smoker. Meat Probe To use meat probe: • Insert meat probe into center of meat to get most accurate reading. •...
  • Page 10: How To Use Control Panel

    HOW TO USE WOOD CHIP LOADER HOW TO USE CONTROL PANEL Pre-soak wood chips in water for at least 30 minutes. Before starting unit, place 1 cup of wood chips in chip loader. Never use more than 1 cup of wood chips at a time.

Table of Contents