Comtech EF Data Vipersat CDM-570 User Manual page 36

I n i t i a l C o n f i gu r a t i o n
7.
8.
9.
10. Save the settings to flash by entering S at the command prompt.
This completes the initial configuration of a CDM-570/570L from the factory
default settings to a functioning, Vipersat-enabled unit. Additional configura-
tion parameters must be set depending on the network requirements for a
specific application.
Refer to Chapter 3, "Using the Command Line Interface," for additional details
on configuring the target Vipersat CDM-570/570L.
2-12
units in the network that are managed by the VMS. The Receive Multicast
Address of this CDM-570/570L must match the Transmit Multicast
Address that has been assigned to the VMS.
Enter I at the command prompt to set the Managing IP Address.
The Managing IP Address is the IP address of the VMS server.
Management Security (Optional)
If this is an encrypted network, enter K at the command prompt to con-
figure Vipersat Management Security.
Enter H to go to the Home State Configuration menu screen, then enter
W to set the current configuration as the Home State.
V i p e r s a t C D M - 5 7 0 / 5 7 0 L U s e r G u i d e