Before You Begin; Parts List - AT&T 2325 User Manual

BEFORE YOU BEGIN

Parts List

Your box should include:
USER'S MANUAL
2.4 GHz Cordless Telephone
Answering System 2325/2365
with Caller ID/Call Waiting
Part 1 — Important
Product Information
© 2002 Advanced American Telephones. All rights reserved.
AT&T and the Globe Design are trademarks of AT&T Corp. licensed to Advanced American Telephones.
Base Unit
Power
adapter
NOTE: If you have purchased the AT&T 2365, please also refer to
the parts list in your AT&T 2300 User's Manual.
This User's
Manual
Part 2
Please also read
NiCd
battery pack
QUICK START GUIDE
2.4 GHz Cordless Telephone
2325/2365 with Caller ID/Call Waiting
INSTALLATION
Modular Standard
telephone
electrical
Table/Desk Installation
jack outlet
Line Cord Power Cord
NOTE: Install this telephone away from
electronic equipment, such as personal
computers, television
sets or microwave ovens. Avoid excessive heat,
cold, dust or moisture.
1 Connect the telephone line cord. (figure a)
2
Connect the power cord to the base and
an electrical outlet not controlled by a wall
switch. (figure a) The ANSWER ON/OFF light
goes on, and CL flashes in the message window.
figure a
Use only the power cord supplied with this product.
If you need a replacement, call 1 800 222–3111.
3 Install the handset battery. Use only AT&T
Battery 3301, SKU# 91076. (figure b)
4 Charge the handset battery.
• Place the handset in the base.
• Charge the battery at least 12 hours.
After the first charge, the battery will
charge in eight hours. a) Remove battery b) Plug the battery pack
compartment cover by connector into handset.
5
Check for dial tone. pressing on indentation Place the battery pack and
and sliding downward. wires in the compartment.
• After the batteries are charged, lift the
handset and press P; you should
hear a dial tone.
c) Replace cover by
For detailed instructions for wall installation, to
sliding it on its
remove the belt clip, or use a headset with this phone
track up over
please refer to the INSTALLATION section of your
battery case until
User's Manual . it snaps firmly
into place.
NOTE: If you have purchased the AT&T 2365,
you must place the fully charged 2300
Expansion Headset into your 2365 base for
figure b
registration. Refer to your 2300 User's Manual
for more etials.
Wallet
Card
Answering System 2325/2365
Remote Commands
To connect with your answering system:
1 Dial your telephone number from a touch tone phone.
2 When the system answers enter your Remote Access
Code (preset to 50).
3 Within 10 seconds, enter a remote command from inside
this card.
2 Telephone
line cord
Quick
Start
Guide
Handset
1