Table of Contents
Advertisement
Parameter Data Format
b
Connect time limit
This parameter specifies the maximum period of time for which the open state
of the connection can be maintained before the TARG starts the closing
processing as a multiple of 100 μs.
This value of the HDD is infinite. This parameter cannot be changed by
INITs.
The HDD ignores the value specified for this parameter.
c.
Maximum burst size
This parameter specifies the maximum number of transfer bytes that the
TARG transfers in the data frames between the OPEN processing for the
address frame and the execution of the DONE-CLOSE primitive as a multiple
of 512 bytes.
The HDD ignores the value specified for this parameter.
d.
First burst size
When the ENABLE FIRST BURST bit of the command frame is set to "1,"
this parameter specifies the maximum number of write data bytes that an INIT
can transfer without transferring XFER_RDY frames immediately after
transfer of a command frame. The number of bytes is specified in this
parameter as a multiple of 512 bytes.
Since the HDD does not support the ENABLE FIRST BURST function for
command frames, this parameter is ignored if specified.
288
C141-C013
Advertisement
Table of Contents
