Table of Contents
Advertisement
c) Any cases other than the above indicate that it was impossible to execute the
command or the command ended abnormally.
(3) CONDITION MET Status
Not supported.
(4) BUSY status
This status indicates that the HDD is busy, and it cannot accept a new command.
Usually, an INIT that has received this status re-issues the same command after an
adequate period of time.
The HDD reports the BUSY status when the WRITE BUFFER command is issued
to download a microcode while the HDD has commands in its command queue
that have not been executed yet.
(5) INTERMEDIATE status
Not supported.
(6) INTERMEDIATE CONDITION MET Status
Not supported.
(7) RESERVATION CONFLICT status
This status indicates that the HDD is currently reserved by another INIT and use
is impossible until the reservation status is released. Normally, an INIT that
receives this status reissues the original command after waiting for the appropriate
period of time only.
(8) COMMAND TERMINATED status
Not supported.
(9) TASK SET FULL status
This status is reported when there is no empty space in the command queue and
the HDD cannot register tagged commands it has received in the command queue.
C141-C013
2.2 Status Byte
109
Advertisement
Table of Contents
