Installing The Power Switch; Removing The Input/Output Panel - Dell OptiPlex 9010 Owner's Manual

Installing The Power Switch

1. Slide the power-switch cable in through the front of the computer.
2. Secure the power-switch cable to the chassis.
3. Connect the power-switch cable to the system board.
4. Install the front bezel.
5. Install the cover.
6. Follow the procedures in

Removing The Input/Output Panel

1. Follow the procedures in
2. Remove the
a) cover
b) front bezel
c) hard drive
d) optical drive
3. Disconnect the 24–pin connector from the system board.
After Working Inside Your Computer .
Before Working Inside Your Computer .
33